Programming the Memco Oven/Furnace Controller

Step Generation for the Memco Oven/Furnace Controller

Enter the information requested below. You must make a selection for each option. Enter temperature as degrees F (fahrenheit). Starting times are calculated from 5:00pm and based on overnight burnouts. If you want to start the controller right away, when the programming steps are displayed, skip the first step and input remaining steps (ie #2 now becomes #1 and so forth). Note: to achieve the shortest burnout possible, you should steam dewax your flasks and use Stone Saver in your investment.

What time do you want the flasks to be ready to cast:

Flask diameter:
(use the size of the largest flask you will be burning out
if your flask size is not shown, select the size that is closest
to yours)

Flask Casting Temperature:
Check with your alloy provider to get this temperature. You may use the
chart below if you are not sure what temperature your flask should be.

Alloy	Casting Temp ºC	Ratio Metal/Wax	Flask Temp ºF
Aluminum	720	2.5	450
Brass 85/15	1120	8.5	1110
Ferrium B	1540	7.7	1600
Yellow Gold 10K	977	11.5	960
White Gold 10K	1149	11.0	1130
Yellow Gold 14K	950	13.0	935
White Gold 14K	1066	12.5	1050
Yellow Gold 18K	996	15.5	985
White Gold 18K	1013	14.5	1000
Sterling Silver	980	10.2	990

Are you steam dewaxing your flasks? Yes No

Are you using Stone Saver? Yes No

Are you casting stones in place? Yes No

Please review the above before submitting